Nokia 6800 Series Manuel d'utilisateur Page 97

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 151
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 96
Chapter 8: VPD-6830 Programmable Video DA Series VPD-6830-CLP
70 6800/7000 Series - Distribution and Routing Products Installation and Operation Manual
VPD-6830-CLP
Configuration
1. Set the input coupling for either AC or DC coupling using jumpers
J2 and J3. See Figure 8-3 on page 71 for jumper locations.
2. Set the Clamping mode on jumper J1 to either Soft, Hard or No
Clamp. See Figure 8-3 on page 71 for jumper location.
3. Adjust the gain over a range of -3 dB to +3 dB using the R5
multi-turn potentiometer in the base module.
Turn the potentiometer Clockwise to Increase the gain. See
Figure 8-4 on page 71.
4. Adjust the equalization using the R6 multi-turn potentiometer in the
base module.
Turn the potentiometer clockwise to obtain more equalization. See
Figure 8-4 on page 71.
5. Make fine adjustments to the high-frequency response using the R21
Single-Turn potentiometer in the base module.
The high-frequency response is factory-set/calibrated.
Readjustment is not recommended without precise test equipment.
See Figure 8-4 on page 71.
6. Adjust the Hard clip level using the R4 multi-turn potentiometer
located on the VPD-6830-CLP submodule. See Figure 8-3
VPD-6830-CLP Configuration on page 71.
7. Adjust the Luminance clip using the R13 multi-turn potentiometer
located on the card edge of the submodule card. See Figure 8-4
VPD-6830-CLP Card-Edge View” on page 71.
Vue de la page 96
1 2 ... 92 93 94 95 96 97 98 99 100 101 102 ... 150 151

Commentaires sur ces manuels

Pas de commentaire